Brown – PLA Filament

Original price was: AED 120.Current price is: AED 85.

In stock (can be backordered)

Chocolate Brown with its intensely dark brown color is a true homage to the great Belgium chocolates, if only it tasted as good! If this shade of brown is a bit too dark for you, take a look at our milky Light Brown.

Product Description

Chocolate Brown with its intensely dark brown color is a true homage to the great Belgium chocolates if only it tasted as good!

Colour: Brown

Material: PLA

Diameter: 1.75mm (+/- 0.05mm)

Tips & Tricks

At Xplorer 3D we have a well equipped 3D printing studio with a couple of different 3D printers. We know our materials will give you excellent results and to help you get these results here are tips and trick for using Xplorer 3D 3d printing filament.

Advise 3d printing temperature:

190-210C*

Advise 3d print speed:

40 – 100 mm/s

Advised Heated bed (if you have one, not strictly necessary):

50-60C

Build platform

Our PLA performs well on both heated and non-heated build platforms. For those users printing on a cold build platform, we advise applying masking tape to the build area. The rough surface of the tape will provide enough adhesion for the first layer to stick and print almost without any warping.

Users using heated build platforms have quite a few options these days. The usual suspects are glass and aluminum build plates. For directly printing on glass or aluminum we advise the user to apply glue-stick. A very thin layer will be sufficient to keep your print nicely in place. Another method is dissolving wood glue in water, you the consistency of the substance can be quite thin, a bit like milk. By applying just a few drops and smearing this out before you start heating the built plate will create a very thin layer which holds the PLA down very well. If applying this method, be careful that you don’t get your electronics wet.

Another method that works well with Xplorer 3D PLA is polyimide tape or Kapton tape. This tape is available as a very narrow strip or very wide strips which allow you to cover the build plate in one go. When the tape is applied correctly it can last for months.

TIP! Take your time leveling the bed and adjusting the gap between 3d printer nozzle and build plate. A perfect first layer will is very important, especially for 3d prints with a large bottom layer. Having the nozzle set to close to the build plate will cause a pressure build-up and as a result, back flow in most hot ends.

TIP! PLA has very minimal warping tendencies, however, if your printing parts which take up the maximum of you build space you might see some warping. If it’s very important that your part is perfectly flat than we suggest to turn down the fan that is cooling your part. This allows the material to slowly get rid of heat without warping. After a few centimeters, you can turn on the cooling if the part needs it.

*3d printers have lots of different types of hot-end which makes it extremely difficult to give a temperature advice. We feel our temperature advice holds for most 3d printers but should be considered as a starting point for you to find the temperatures that work in your setup. Don’t be afraid to go either higher or lower then our advised temperatures if you feel your set-up needs this.

Additional Information

Weight 1 kg